Toro 07200 Operator's Manual page 31

GREASING BEARINGS AND
BUSHINGS
WARNING
Before servicing or making adjustments to the
machine, stop the engine, set the parking brake and
remove key from the ignition switch. Any load
material must be removed from bed or other attach-
ment before working under raised bed. Never work
under a raised bed without positioning safety sup-
port on a fully installed cylinder rod. Always rotate
the safety support to the down position before
working under the raised bed.
The vehicle has grease fittings that must be lubricat-
ed regularly with No. 2 General Purpose Lithium
Base Grease. If the machine is operated under nor-
mal conditions, lubricate all bearings and bushings
after every 100 hours of operation. More frequent
lubrication is required if used for heavy duty vehicle
operations.
The grease fitting locations and quantities are: Tie
rod ends (4) Fig. 16; front ball joints (4) Fig. 16; rear
drive shafts (6) Fig. 172; Mid-drive shaft—4 wheel -
drive only (3) Fig. 18; pedal pivots (4) Fig. 19; steer-
ing shaft (1) Fig. 20; front pivot bushings (2) Fig. 21
and governor Lever (1) Fig. 22.
IMPORTANT: When greasing drive shaft univer-
sal shaft bearing crosses, pump grease until it
comes out of all 4 cups at each cross.
1. Wipe the grease fitting clean so foreign matter
cannot be forced into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe off excess grease.
Maintenance
Figure 16
Figure 17
Figure 18
31