Toro 03540 Operator's Manual page 43

2. Remove and discard the oil filter. Install a new
oil filter.
3. Refill the oil pan with SAE10W30 motor oil.
4. Start the engine and run at idle speed for
approximately two minutes.
5. Stop the engine.
6. Thoroughly drain all fuel from the fuel tank,
lines and the fuel filter/water separator
assembly.
7. Flush the fuel tank with fresh, clean diesel fuel.
8. Resecure all fuel system fittings.
9. Thoroughly clean and service the air cleaner
assembly.
10. Seal the air cleaner inlet and the exhaust outlet
with weatherproof tape.
11. Check anti-freeze protection and add as needed
for expected minimum temperature in your
area.
IDENTIFICATION AND
ORDERING
MODEL AND SERIAL NUMBER
The model and serial number is on a plate that is
mounted on the left side of footrest. Use model and
serial number in all correspondence and when
ordering parts.
To order replacement parts from an authorized
TORO Distributor, supply the following information:
1. Model and serial numbers of the machine.
2. Part number, description and quantity of parts
desired.
Note: If using a parts catalog, do not order by
reference number; use the part number
instead..
Maintenance
43