Table of Contents
Advertisement
Controls System
Maintenance
Adjusting the Control-Lever
Neutral-Interlock Switch
1. Stop the machine, move the motion-control levers to
the N
-
EUTRAL
LOCK
and remove the ignition key.
2. Remove the bolts securing the front panel and remove
the panel
(Figure
50).
2
1
Figure 50
1. Bolt
2. Control panel
3. Loosen the 2 screws securing the interlock switch
(Figure
51).
position, set the parking brake,
G020875
1. Control lever
2. Neutral-interlock switch
4. Holding the control lever against the frame, move the
switch toward the lever until the distance between the
lever and switch body is 0.4 to 1 mm (0.015 to 0.045
inch) as shown in
5. Secure the switch.
6. Repeat steps
3
to
7. Install the front panel.
Adjusting the Control-Lever
Neutral Return
If the motion-control levers do not align with the neutral
slots when released from the R
is required. Adjust each lever, spring, and rod separately.
1. Disengage the PTO, move the control lever to the
N
-
EUTRAL
LOCK
2. Move the throttle lever to the S
the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Remove the bolts securing the front panel and remove
the panel
(Figure
45
Figure 51
3. Screw
4. 0.4 to 1 mm (0.015 to
0.045 inch)
Figure
51.
5
for the other lever.
position, adjustment
EVERSE
position, and set the parking brake.
position, shut off
LOW
52).
Advertisement
Table of Contents
