Engine Temperature Gauge; Key Switch; Speed Limiter; Pto Switch - Toro 30413 Operator's Manual

Engine Temperature Gauge

This gauge (Figure 2) indicates the engine coolant
temperature.

Speed Limiter

Adjust the screw (Figure 3) to limit the amount the
traction pedal can be depressed in the forward direction
to limit speed.
Important: The traction pedal must contact the
speed limiter before reaching the end of the pump
stroke to prevent pump damage.
1. Speed limiter
Important: When in the mow position, the speed
limiter screw must stop the traction pedal before the
pump reaches full stroke or damage to the pump
may occur.
Lift Levers
The lift levers (Figure 4) raise and lower the cutting units.
Important: The center lift lever must momentarily
be pushed to the lower position to enable PTO
circuit actuation by PTO switch.
Cutting Unit Service Lock
The cutting unit service lock (Figure 4) locks the front
cutting unit lift lever when the cutting unit is in the
raised position.
Figure 3

Key Switch

The key switch (Figure 4) has three positions: Off,
On/Preheat, and Start.

PTO Switch

The PTO switch (Figure 4) has three positions: On
(engage), Neutral, and Off (disengage). Carefully lift
and push the PTO switch forward to the On position
to start the implement or cutting unit blades. Slowly
pull the switch backward to the Off position to stop
implement operation.
Important: The center lift lever must momentarily
be pushed to the lower position to enable PTO
circuit actuation by PTO switch.
Hi-Lo Speed Control (Optional)
The control (Figure 4) allows the speed range to increase
for transport of the machine.
1. Lift lever
2. Key switch
3. PTO switch
4. Hi-lo speed control
(optional)
5. Flow divider switch
6. Cruise control (optional)
7. Alarm silence switch
8. Fan switch
Cruise Control (Optional)
The cruise control (Figure 4) sets the speed of the
machine.

Fuel Gauge

The fuel gauge (Figure 4) indicates the level of fuel in
the tank.
16
Figure 4
9. Audible alarm
10. Temperature reset switch
11. Hour meter
12. Fuel gauge
13. Throttle
14. Power point
15. Front cutting unit service
lock