Product Overview; Controls - Toro 38700 Operator's Manual

Product Overview

1. Wheel-clutch lever
2. Handle
3. Broom-angle lever
4. Broom-drive lever
5. Speed-selector lever

Controls

Determine the left and right sides of the machine from the
normal operating position.
Choke Control
The choke control is the top lever located on the rear, left
side of the engine above the fuel-shutoff valve
The choke is used to aid in starting a cold engine. Move the
lever left to the O position for a cold start. Do not run a
N
warm engine with the choke in the O
Figure 4
6. Traction-drive lever
7. Fuel cap
8. Broom
9. Broom-height-adjustment
pin
(Figure
position.
N
1. Choke control
2. Fuel-shutoff valve
3. Throttle control
Fuel-Shutoff Valve
Use the fuel-shutoff valve to shut off the flow of fuel when
you will not use the machine for a few days, park the machine
inside a building, or transport the machine to and from the
job site (Figure
Move the lever to the left to shut off the fuel. Move the lever
to the right to turn on the fuel.
Throttle Control
The throttle control is located on the rear, right side of the
5). engine and below the fuel tank
The throttle is used to control engine speed. Moving the
throttle control to the left increases the engine speed, and
moving it right decreases the engine speed.
Engine On/Off Switch
Located on the right side of the engine
Rotate the switch clockwise to the O
the engine. Rotate the switch counterclockwise to the O
position to stop the engine.
9
Figure 5
4. Engine-recoil handle
5. Engine On/Off switch
5).
(Figure 5).
(Figure
position before starting
N
5).
FF