Toro 38700 Operator's Manual page 26

1. Spacer
2. Pulley shield
3. Belt guide
3. Slip the belt forward over the forward groove of the
engine pulley (Figure
1. Engine pulley
2. Broom drive belt
4. Slip the belt off of the broom-gearbox pulley,
move the belt rearward between the pulley and the
traction-control bracket, and remove the belt from the
machine (Figure 40).
Installing the Broom-Drive Belt
1. Align the replacement belt between the pulley and the
traction-control bracket
2. Slip the belt onto the groove at the bottom of the
broom-gearbox pulley
3. Slip the belt onto the forward groove of the engine
pulley (Figure 40).
Figure 39
4. Washer
5. Bolt
40).
Figure 40
3. Broom-gearbox pulley
4. Traction-control bracket
(Figure 40).
(Figure 40).
Note: Ensure that the belt is not twisted.
4. Align the spacer between the engine and the pulley
shined and align the holes in the spacer, engine, and
shield (Figure 39).
5. Secure the pulley guide to the machine with the bolts
and washers (Figure
Removing the Broom-Drive Belt (page
Removing the Traction Belt
1. Remove the broom-drive belt; refer to
Broom-Drive Belt (page
2. Remove the hairpin from the traction-control rod
(Figure 41).
1. Hairpin
2. Traction-control rod
3. Remove traction-control rod from the traction-control
bracket by moving the rod inward
4. Pivot the traction-control bracket and traction pulley
forward (Figure
1. Tension pulley
2. Rear groove (engine
pulley)
3. Traction belt
5. Pull the tension pulley outward
26
39) that you removed in step
25).
Removing the
25).
Figure 41
3. Traction-control bracket
(Figure
42).
Figure 42
4. Traction pulley
5. Traction-control bracket
(Figure 42).
2 of
41).