Table of Contents
Advertisement
4. Disengage the parking brake to push the machine.
2
Figure 14
1. Position for pushing the
machine
To Operate the Machine
Pull each bypass lever up and pull them completely out.
Push the levers down (Fig. 14).
Note: The machine will not drive unless the bypass levers
are pulled out.
Removing the Recycler Baffle
Remove the right side baffle to convert from mulching to
the side discharge mode.
1. Thoroughly clean the mower.
2. Remove the lock nuts from the top and center of the
right side baffle (Fig. 15).
3. Lower the baffle and slide it out of discharge opening to
remove it (Fig. 15).
Note: Only the right side baffle needs be removed for side
discharge mowing.
4. Install the previously removed bolts (5/16 x 5/8 inch)
and locknuts (5/16 inch) in the open holes of the mower
for safety (Fig. 15).
1
m–5139
2. Position for operating the
machine
19
3
2
2
3
Figure 15
1. Baffle left side
2. Bolt, 5/16 x 5/8 inch
Warning
Open holes in the mower expose you and others to
thrown debris which can cause severe injury.
Never operate the mower without hardware
mounted in all holes in the mower housing.
Install the hardware in the mounting holes when
you remove the recycling baffle.
Installing the Recycler Baffle
Install the right side baffle to convert from side discharge
mode to mulching.
1. Thoroughly clean the mower.
2. Remove the bolts and nuts in the holes needed for the
baffle (Fig. 15).
3. Install the baffle by sliding it into the discharge opening
(Fig. 15).
4. Secure the baffle with the nuts and bolts (Fig. 15).
3
1
2
m-2414
3. Lock nut, 5/16 inch
Advertisement
Table of Contents
