Toro 41165 Operator's Manual page 22

Tank Drain Handle
The tank drain handle is located on top of the tank
(Fig. 23). Pull the handle out to drain the tank.
Important Pull the handle gently out until it stops. Do
not pull too hard or you may damage it.
1
Figure 23
1. Tank drain handle
Tank Cover
The tank cover is located in the center of the top of the tank
(Fig. 24). To open it, turn off the engine, then turn the front
half of the cover to the left and swing it open. You can
remove the strainer inside for cleaning. To seal the tank,
close the cover and rotate the front half toward the right.
1
Figure 24
1. Tank cover
Anti-siphon Fill Receptacle
To the front of the tank cover is a hose receptacle with a
threaded fitting, a 90 degree barbed fitting, and a short hose
which you can direct toward the tank opening (Fig. 24).
This receptacle allows you to connect a water hose to it and
fill the tank with water without contaminating the hose with
the chemicals in the tank.
Important Do not lengthen the hose to allow contact
with the tank fluids.
2
2. Anti-siphon fill receptacle
22
Fresh Water Tank
The fresh water tank is located at the front, left side of the
tank (Fig. 25). It supplies you with a source of fresh water
for you to wash chemicals off of your skin, eyes, or other
surfaces in the case of accidental exposure. Always fill the
fresh water tank with clean water before handling or
mixing any chemicals.
To open the fresh water tank spigot, turn the lever on the
spigot.
1
2
Figure 25
1. Filler cap
2. Fresh water tank
Rinse Tank
The rinse tank is located at the front, right side of the tank
(Fig. 26). If you install the optional Rinse Kit, you can fill
this tank with fresh water and automatically rinse the tank.
1
Figure 26
1. Rinse tank (for use with the optional rinse kit)
3
3. Spigot