Towing The Sprayer; Sprayer Controls And Components - Toro 41165 Operator's Manual

Towing the Sprayer

In case of an emergency, the sprayer can be towed for a
short distance. However, we do not recommend this as a
standard procedure.
Warning
Towing at excessive speeds could cause a loss of
steering control, resulting in personal injury.
Never tow the sprayer faster than 5 mph (8 kph).
Towing the sprayer is a two person job. If the machine must
be moved a considerable distance, transport it on a truck or
trailer; refer to Transporting the sprayer, page 19.
1. Affix a tow line to the frame.
2. Put the range selector in the Neutral position and release
the parking brake.
3. Tow the sprayer at less than 5 mph (8 kph).
Sprayer Controls and
Components
Master Boom Switch
The master boom switch allows you to start or stop the
spray operation. Press the switch with your foot to enable
or disable the spray system (Fig. 18). When the master
switch is off, the Spray Pro screen reads "Hold."
Figure 18
1. Master boom switch
Boom Switches
The boom switches are located at the front of the control
panel to the right of the seat (Fig. 19). Toggle each switch
forward to turn the corresponding boom section on and
rearward to turn them off. When the switch is turned on, a
light on the switch illuminates. These switches will only
affect the spray system when the master boom switch is on.
1. Boom switches
2. Pump switch
Pump Switch
The pump switch is located on the control panel to the right
of the seat (Fig. 19). Toggle this switch forward to run the
pump or rearward to stop the pump.
Application Rate Switch
The application rate switch is located on the control panel
to the right of the seat (Fig. 19). Press and hold the switch
forward to increase the spray system pressure, or press and
hold it rearward to decrease pressure.
1
Rate Lockout Key Switch
The rate lockout key switch is located on the control panel
to the right of the seat (Fig. 19). Turn the key
counterclockwise to the locked position to disable the
application rate switch, thereby keeping anyone from
accidentally changing the application rate. Turn the key
clockwise to the unlocked position to enable the application
rate switch.
Boom Lift, Sonic Boom, and Foam Marker
Switch Locations
If you install the electric boom lift, sonic boom, and foam
marker kit, you will add switches to the control panel for
controlling their operation. The sprayer comes with plastic
plugs in these locations.
20
1 1 1
4
2
3
Figure 19
3. Application rate switch
4. Rate lockout key