Using The Cylinder Lock; Using Attachments - Toro 22321 Operator's Manual

Figure 17
1. Left tow valve (right track)
4. Tow the traction unit as required.
5. When the traction unit has been repaired, close the
tow valves before operating it.

Using the Cylinder Lock

The loader arms may lower when in the raised
position crushing anyone under them.
Install the cylinder lock before performing
maintenance that requires raised loader arms.
Installing the Cylinder Lock
1. Remove the attachment.
2. Raise the loader arms to the fully raised position.
3. Stop the engine.
4. Remove the lynch pin securing the cylinder lock to
the loader arm (Figure 18).
2. Right tow valve (left track)
1. Cylinder lock
2. Lift cylinder
5. Lower the cylinder lock over the cylinder rod and
secure it with the lynch pin (Figure 18).
6. Slowly lower the loader arms until cylinder lock
contacts the cylinder body and rod end.
Removing/Storing the Cylinder Lock
Important: Ensure that the cylinder lock is
removed from the rod and fully secured in the
storage position before operating the traction unit.
1. Start the engine.
2. Raise the loader arms to the fully raised position.
3. Stop the engine.
4. Remove the lynch pin securing the cylinder lock.
5. Rotate the cylinder lock up to the loader arm and
secure it with the lynch pin.
6. Lower the loader arms.

Using Attachments

Important: If you are using an attachment with a
serial number of 200999999 or earlier, the manual
for the attachment may contain information
specific to the use of the attachment with other
traction unit models, such as settings for the flow
divider control and speed selector lever and the
use of a counterweight on the traction unit. These
systems are built into the TX, and you should
ignore any references to them.
Installing an Attachment
Important: Use only Toro-approved attachments.
Attachments can change the stability and the
operating characteristics of the traction unit. The
19
1
G004182
Figure 18
3. Lynch pin
3
2