Toro 04357 Operator's Manual page 33

Figure 43
• Speed selector linkage (Figure 44 & Figure 45)
Figure 44
Figure 45
To grease the machine, complete the following
procedure:
1. Wipe the grease fitting clean so foreign matter
cannot be forced into the bearing or bushing.
2. Pump grease into the bearing or bushing until the
grease is visible. Wipe up excess grease.
3. Apply grease to the reel motor spline shaft and onto
the lift arm when the cutting unit is removed for
service.
4. Apply a few drops of SAE 30 engine oil or spray
lubricant (WD 40) to all pivot points daily after
cleaning.
33