Adjusting The Motion Control Damper - Toro 74939 Operator's Manual

6. Run the unit at least 5 minutes with the drive levers
at full forward speed to bring the hydraulic oil up to
operating temperature.
Note: The motion control lever needs to be in neutral
while making any necessary adjustments.
7. Bring the motion control levers into the neutral
position. Adjust the pump control rod lengths by
rotating the double nuts on the rod in the appropriate
direction until the wheels slightly creep in reverse
(Figure 83). Move the motion control levers to the
reverse position and while applying slight pressure to
the lever allow the reverse indicator springs to bring the
levers back to neutral. The wheels must stop turning
or slightly creep in reverse.
g019757
Figure 83
1. Double nuts
8. Shut off the machine. Remove the jumper wire from
the wire harness and plug the connector into the seat
switch.
9. Remove the jack stands.
10. Raise the deck and install the height-of-cut pin.
11. Check that the machine does not creep in neutral with
the park brakes disengaged.
Adjusting the Motion Control
Damper
The top damper mounting bolt can be adjusted to obtain a
more desired motion control lever resistance. See Figure 84
for mounting options.
Right Hand motion control shown
1. Torque the locknut to 200 in-lb (16.7 ft-lb). The bolt must
protrude past the end of the locknut after being torqued.
2. Most resistance (firmest feel)
3. Damper
4. Medium resistance (medium feel)
5. Least resistance (softest feel)
52
Figure 84