Specifications - Toro 74939 Operator's Manual

With 60in and 70in turbo force side discharge mower
Table of Contents

Advertisement

Blade Control Switch (PTO)
The blade control switch (PTO) is used to engage the electric
clutch and drive the mower blades. Pull the switch up to
engage the blades and release. To disengage the blades, push
the blade control switch (PTO) down or move a motion
control lever into the neutral lock position.
Ignition Switch
This switch is used to start the mower engine and has three
positions: Start, Run, and Off.
Motion Control Levers
The motion control levers are used to drive the machine
forward, reverse, and turn either direction.
Neutral Lock Position
The neutral lock position is used with the safety interlock
system to engage and to determine neutral position.
Fuel Shut-off Valve
Close the fuel shut-off valve (under the seat) when
transporting or storing the mower.
Electronic Control Unit Malfunction
Indicator Light
The electronic control unit (ECU) continuously monitors the
operation of the EFI system.
If a problem or fault within the system is detected, the
malfunction indicator light (MIL) is illuminated.
The MIL is the red light located in the right console panel.
Once the MIL illuminates, initial trouble shooting
checks should be made. Refer to the MIL section under
Troubleshooting (page 63).
If these checks do not correct the problem, further diagnosis
and servicing by an Authorized Service Dealer is necessary.
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.

Specifications

Note: Specifications and design are subject to change
without notice.
Width:
60 inch Deck
Options
Without Deck
53.0 inches (134.6
cm)
Deflector Up
61.7 inches (156.8
cm)
Deflector Down
75.7 inches (192.2
cm)
Length:
60 inch Deck
Option
Roll Bar - Up
83.1 inches (211.1
cm)
Roll Bar - Down
84.8 inches (215.4
cm)
Height:
Roll Bar - Up
70.5 inches (179.1 cm)
Weight:
Model
74939
74940
14
72 inch Deck
59.1 inches (150.1
cm)
73.6 inches (187
cm)
87.6 inches (222.4
cm)
72 inch Deck
83.1 inches (218.7
cm)
87.8 inches (223.0
cm)
Roll Bar - Down
46.8 inches (118.9 cm)
Weight
1269 lb (576 kg)
1349 lb (612 kg)

Advertisement

Table of Contents
loading

This manual is also suitable for:

74940Z master professional 6000 series

Table of Contents