Key Switch - Toro Dingo 320-D Operator's Manual

Key Switch

The key switch, used to start and stop the engine, has
three positions: stop, run, and start.
To start the engine, rotate the key to the start position.
Release the key when engine starts and it will move
automatically to the run position.
To stop the engine, rotate the key to the stop position.
Throttle Lever
Move the control forward to increase the engine speed and
rearward to decrease speed.
Traction Control Levers
To move forward, move the traction control levers
forward. To move rearward, move the traction control
levers rearward.
To go straight, move both traction control levers equally.
To turn, move the lever located on the side you want to
turn back toward the neutral position while keeping the
other lever engaged.
The farther you move the traction control levers in either
direction, the faster the traction unit will move in that
direction.
To slow or stop, move the traction control levers to
neutral.
Attachment Tilt Lever
To tilt the attachment forward, slowly push the attachment
tilt lever forward.
To tilt the attachment rearward, slowly pull the attachment
tilt lever rearward.
Loader Arm Lever
To lower the loader arms, slowly push the loader arm
lever forward.
To raise the loader arms, slowly pull the loader arm lever
rearward.
Loader Valve Lock
The loader valve lock secures the loader arm and
attachment tilt levers so that you cannot push them
forward. This helps to ensure that no one will accidentally
lower the loader arms during maintenance. Secure the
loader arms with the lock anytime you need to stop the
machine with the loader arms raised.
To set the lock, pull it back and all the way down against
the levers (Fig. 13).
Note: You will need to move the levers rearward to
engage or disengage the loader valve lock.
m-6025/6026
Figure 13
1. Loader valve lock,
engaged
Auxiliary Hydraulics Lever
To operate a hydraulic attachment in a forward direction,
push the lever to the left, out of the neutral slot, and
slowly pull the auxiliary hydraulics lever rearward.
To operate a hydraulic attachment in reverse direction,
push the lever to the left, out of the neutral slot, and
slowly push the auxiliary hydraulics lever forward. You
can also set the lever so that the reverse hydraulics are on
without operator presence. To do so, move the lever
completely to the left and then forward until the lever
remains in the reverse position.
Speed Selector Lever
Move the speed selector lever to the fast (rabbit) position
to set the traction drive, loader arms, and attachment tilt to
high speed and the auxiliary hydraulics to low speed.
17
2
1
2. Loader valve lock,
disengaged