Lifted Height Of Outer Front Cutting Units (Enable Position); Installing The Rear Weight - Toro 03540 Operator's Manual

"A"
"C"
Figure 13

Installing the Rear Weight

The Reelmaster 5200-D & 5400-D Traction Units comply with ANSI B71.4-1999 Standards when equipped with rear weight
and 90 lb. of calcium chloride ballast is added to rear wheels. Use chart below to determine combinations of weight required.
Order parts from your local Authorized Toro Distributor.
2wd Traction Unit with ROPS
w/o baskets
2wd Traction Unit with ROPS
with baskets
2wd Traction Unit w/o ROPS
w/o baskets
2wd Traction Unit w/o ROPS
with baskets
4wd Traction Unit with ROPS
w/o baskets
4wd Traction Unit with ROPS
with baskets
Important
If a puncture occurs in a tire with calcium chloride, remove unit from turf area as quickly as possible. To
prevent possible damage to turf, immediately soak affected area with water.
"B" Lifted Height of Outer Front
Cutting Units (Enable Position)
The turnaround height of the front outer cutting units (#4 &
#5) may be increased to provide additional ground
clearance on contoured fairways. Contact your distributor
for assistance in adjusting the ECU settings.
Rear Weight Weight Part
Required Number
291 lb. 75-6690
358 lb. 75-6690
157 lb. 75-6690
224 lb. 75-6690
157 lb. 75-6690
75-6690
249 lb.
98-9780
17
Weight Description
Rear Weight Kit
Rear Weight Kit
Rear Weight Kit
Rear Weight Kit
Rear Weight Kit
Rear Weight Kit
Rear Weight Kit—25 lb.
Qty.
3
4
1
2
1
2
1