Changing The Transaxle Fluid; Replacing The Fuses - Toro 07252 Operator's Manual

Changing the Transaxle Fluid

Change the transaxle fluid every 800 operating hours or
yearly, whichever occurs first.
1. Position the vehicle on a level surface, set the parking
brake, turn the ignition off, and remove the key.
2. Remove the drain plug from the right side of the
reservoir (Fig. 41) and let the fluid flow into a drain
pan. Install and tighten the plug when the fluid stops
draining.
Note: Dispose of the used oil at a certified recycling center.
2
Figure 41
1. Drain plug
3. Fill the reservoir (Fig. 42) with approximately 1-1/2 qt.
(1.4 liters) of SAE 10W30 motor oil or until the oil
level is at the bottom of the level indicator hole
(Fig. 41).
Figure 42
1. Oil fill
4. Start the engine and operate it to fill the system.
Recheck the oil level and replenish it, if required.
1
m–4849
2. Level indicator hole
1
35

Replacing the Fuses

There are 3 fuses in the electrical system. They are located
beneath the bed in a box on the right hand side of the frame
(Fig. 43).
Ignition System
Lights
Power Point
1
Figure 43
1. Ignition system
2. Lights
10 amp.
10 amp.
10 amp.
(15 amp. max.)
3
2
m–5323
3. Power point