The Safety-Interlock System - Toro 74919TE Operator's Manual

Important: Make sure that the fuel-shutoff valve is
closed before transporting or storing the machine, as
fuel leakage may occur. Set the parking brake before
transporting the machine. Make sure to remove the key,
as the fuel pump may run and cause the battery to lose
charge.

The Safety-interlock System

CAUTION
If safety-interlock switches are disconnected or
damaged the machine could operate unexpectedly,
causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock switches
daily, and replace any damaged switches before
operating the machine.
Understanding the Safety-interlock
System
The safety-interlock system is designed to prevent the engine
from starting unless:
•
The parking brake is engaged.
Figure 21
•
The blade-control switch (PTO) is disengaged.
•
The motion-control levers are in the neutral-locked
position
The safety-interlock system also is designed to stop the engine
when the motion-control levers are moved from the locked
position with the parking brake engaged or if you rise from
the seat when the PTO is engaged.
The hour meter has symbols to notify the user when the
interlock component is in the correct position. When the
component is in the correct position, a triangle will light up
in the corresponding square.
1. Triangles light up when the interlock components are in the
g017007
correct position
Testing the Safety-interlock System
Service Interval: Before each use or daily
Test the safety-interlock system before you use the machine
each time. If the safety system does not operate as described
below, have an Authorized Service Dealer repair the safety
system immediately.
1. Sitting on the seat, engage the parking brake and move
the blade-control switch (PTO) to on. Try starting the
engine; the engine should not crank.
2. Sitting on the seat, engage the parking brake and
move the blade-control switch (PTO) to off. Move
either motion-control lever (out of the neutral-locked
position). Try starting the engine; the engine should
not crank. Repeat for other control lever.
3. Sitting on the seat, engage the parking brake, move
the blade-control switch (PTO) to off and move the
motion-control levers to neutral-lock position. Now
start the engine. While the engine is running, release the
parking brake, engage the blade-control switch (PTO)
and rise slightly from the seat; the engine should stop.
4. Sitting on the seat, engage the parking brake, move
the blade-control switch (PTO) to off and move the
motion-control levers to neutral-lock position. Now
start the engine. While the engine is running, center
23
G009181
Figure 22
1