Cleaning; Cleaning Under The Mower; Disposing Of Waste - Toro 74919TE Operator's Manual

6 2
1
g015594
Figure 97
1. Bolt
2. Spacer
3. Locknut
4. Spring
2. Place the spacer and spring onto the grass deflector.
Place one J end of the spring behind the deck edge.
Note: Make sure that one J end of the spring is
installed behind the deck edge before installing the bolt
as shown in Figure 97.
3. Install the bolt and the nut. Place one J hook end of
the spring around the grass deflector (Figure 97).
Important: The grass deflector must be able
to rotate. Lift the deflector up to the full open
position and ensure that it rotates into the full
down position.
4
7
3
5
5. Spring installed
6. Grass deflector
7. J hook end of spring

Cleaning

Cleaning under the Mower

Service Interval: Before each use or daily
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the neutral-locked position,
and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Raise the mower to the transport position.

Disposing of Waste

Engine oil, batteries, hydraulic oil, and engine coolant are
pollutants to the environment. Dispose of these according to
your state and local regulations.
62