Attachments - Toro 22302 Operator's Manual

Operation

Attachments

Connecting
IMPORTANT: Use only Toro approved
attachments. Attachments can change the
stability and the operating characteristics of
the machine. The warranty of the machine
may be voided if used with un–approved
attachments.
IMPORTANT: Before connecting any
attachments to machine, make sure mount
plates are free of any dirt or debris.
1. Move pump control lever to slow (turtle)
position. Start engine.
2. Slowly push the attachment tilt lever forward to
tilt the attachment mount plate forward.
3. Position mount plate into the upper lip of the
attachment's receiver plate.
4. Raise the loader arms while tilting back the
mount plate at the same time.
IMPORTANT: The attachment should be
raised enough to clear the ground and the
mount plate tilted all the way back.
5. Turn the ignition key to "OFF" to stop the
engine.
6. Engage the attachment lock pins.
Note: Lock pins are located on the operator
side of the mount plate and should be
turned toward the inside to engage.
Note: Proceed to next step if auxiliary
hydraulics are required with
attachment.
IMPORTANT: Make sure all foreign matter
is cleaned from hydraulic connections before
making connections.
20
7. Move the auxiliary hydraulics lever to the
forward, backward and back to neutral position
to relieve hydraulic pressure at the hydraulic
couplers.
8. Remove protective covers from hydraulic
couplers on machine. Connect covers together to
prevent contamination during operation.
9. Slide collar back on hydraulic coupler and
connect attachment couplers to machine
couplers.
10. Confirm that connection is secure by pulling on
hoses.
Disconnecting
1. Start engine and lower the attachment to the
ground or onto a trailer.
2. Turn the ignition key to "OFF" to stop the
engine.
3. Disengage the attachment lock pins by turning
them to the outside.
4. Slide collar back on hydraulic coupler and
disconnect attachment couplers from machine
couplers.
IMPORTANT: Connect attachment hoses
together to prevent hydraulic system
contamination during storage.
5. Install protective covers onto machine's
hydraulic couplers.
6. Start engine, tilt the mount plate forward and
back machine away from attachment.