Toro 41198 Multi-Pro 1250 Operator's Manual page 60

C. Stop the engine, allow it to cool, and drain the
fuel tank.
D. Restart the engine and run it until it stops.
E. Choke the engine.
F. Start and run the engine until it will not start
again.
G. Dispose of fuel properly. Recycle as per local
codes.
Important: Do not store
stabilizer/conditioned gasoline over 90
days
12. Remove the spark plugs and check their condition;
refer to Changing Spark Plugs in the Engine
Maintenance section.
13. With the spark plugs removed from the engine, pour
two tablespoons of engine oil into the spark plug
hole.
14. Use the electric starter to crank the engine and
distribute the oil inside the cylinder.
15. Install the spark plugs and tighten to recommended
torque; refer to Changing Spark Plugs in the Engine
Maintenance section.
Note: Do not install the wire on the spark plug(s).
16. Remove the battery from the chassis, check the
electrolyte level, and charge it fully; refer to Servicing
the Battery in the Electrical System Maintenance
section.
Note: Do not connect the battery cables to the
battery posts during storage.
Important: The battery must be fully charged
to prevent it from freezing and being damaged
at temperatures below 32 degreesF (0 degreesC).
A fully charged battery maintains its charge for
about 50 days at temperatures lower than 40
degreesF (4 degreesC). If the temperatures will
be above 40 degreesF (4 degreesC), check the
water level in the battery and charge it every 30
days.
17. Check and tighten all bolts, nuts, and screws. Repair
or replace any part that is damaged.
18. Check the condition of all spray hoses, replacing any
that are damaged or worn.
19. Tighten all hose fittings.
20. Paint all scratched or bare metal surfaces.
Paint is available from your Authorized Service
Dealer.
21. Store the machine in a clean, dry garage or storage
area.
22. Remove the ignition key and put it in a safe place out
of the reach of children.
23. Cover the machine to protect it and keep it clean.
60