Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Operator's Manual
ProLine Trimmers
Model No. 53002 — 895001 & Up
Model No. 53003 — 895001 & Up
Model No. 53010 — 895001 & Up
Model No. 53011 — 895001 & Up
16" & 18" Gas
Modèle No. 51903 — 790000001 et suivants
Modèle No. 51904 — 790000001 et suivants
Modèle No. 51906 — 790000001 et suivants
Modèle No. 51907 — 790000001 et suivants
16" & 18" Gas
Modelos N. 51903 — 790000001 y siguientes
Modelos N. 51904 — 790000001 y siguientes
Modelos N. 51906 — 790000001 y siguientes
Modelos N. 51907 — 790000001 y siguientes
Operator's Manual
Manuel de l'Utilisateur
Manual del Usuario
FORM NO. 3322-364
Advertisement
Table of Contents
Related Manuals for Toro 53002
Summary of Contents for Toro 53002
- Page 1 FORM NO. 3322-364 ProLine Trimmers Model No. 53002 — 895001 & Up Model No. 53003 — 895001 & Up Model No. 53010 — 895001 & Up Model No. 53011 — 895001 & Up 16” & 18” Gas Modèle No. 51903 — 790000001 et suivants Modèle No.
-
Page 2: Table Of Contents
....... 53002/Industrial ...... -
Page 3: Introduction
For your convenience, write the product model and serial numbers in the space below. All of us at Toro want you to be completely satisfied with your new product, so feel free to contact your local Authorized Service Dealer for help with service, genuine Toro parts, or other information you may require. -
Page 4: Safety
7. Never use a cutting head or replacement parts that are 3. Always wear hearing protection. not approved by Toro. 8. Maintain the String Trimmer according to the recommended maintenance intervals and procedures in the Maintenance section on page 15. -
Page 5: Power String Trimmer Operating Safety
It is recommended that bystanders wear eye protection. A 12. Use the right tool for the job. Do not use the Trimmer thrown object can ricochet. for any job that is not recommended by Toro. -
Page 6: Safety And Instruction Decals
Safety and Instruction Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. ON SHAFT (Part No. M221501) ON SHAFT (Part No. M221502) ON ENGINE (Part No. -
Page 7: Assembly
Assembly Installing Trimmer Head Shield POTENTIAL HAZARD Foreign objects can be thrown by Trimmer. POTENTIAL HAZARD WHAT CAN HAPPEN The cutoff blade is sharp. Contact with thrown objects can cause personal WHAT CAN HAPPEN injury. Contact with cutoff blade could cause serious HOW TO AVOID THE HAZARD cuts or personal injury. -
Page 8: Installing Trimmer Head
Installing Trimmer Head Before Operation IMPORTANT: Make sure the trimmer head is for Oil and Fuel LEFT-HAND ROTATION (counterclockwise) as viewed from the operator’s position, and that the trimmer head adapter is a male, M8 x 1.25 left-hand thread. 1. Thread the trimmer head into the gearcase, tighten POTENTIAL HAZARD trimmer head firmly by hand (Fig. -
Page 9: Mixing Gasoline And Oil
For your fuel premix, only use a quality oil Recommended Fuel Type designed for 2–cycle air cooled engines. Toro 50:1 2–Cycle Oil is formulated to meet the Use clean, fresh lead-free gasoline, including oxygenated requirements of high-performance, air-cooled or reformulated gasoline, with an octane rating of 85 or two-cycle engines. -
Page 10: Starting And Stopping
4. Keep all bystanders, children and animals away from the working area. Mixing Instructions Cold Starting Procedure The carburetors on Toro engines contain a choke system. IMPORTANT: Never mix gasoline and oil directly in To start a “cold” engine properly, perform the following the String Trimmer fuel tank. - Page 11 Figure 10 1. Stop Switch 4. Throttle Trigger (in idle position) 2. Fast-idle Lock 3. Throttle Trigger (in fast-idle start position) Figure 8 4. After the engine starts, move the choke lever to the open ( ) position, then squeeze and release the 1.
-
Page 12: Hot Restart
5. Hand Holding Throttle If the engine fails to start after you follow the above Grip, Fingers on Throttle 2. Eye Protection procedures, contact an authorized Toro dealer. Trigger 3. Right Arm Slightly Bent 6. Trimmer Head Near and 4. Left Arm Fully Extended,... -
Page 13: Cutting With Nylon Trimmer Line
Always wear gloves and protective clothing when operating the String Trimmer. If the trimmer head becomes jammed, stop the engine immediately. Make certain all moving parts have stopped and disconnect the spark plug before inspecting the equipment for damage. Never use a String Trimmer that has chipped, cracked or broken trimmer head. -
Page 14: Rewinding The Trimmer Spool
Scaling Rewinding the Trimmer Spool To remove unwanted vegetation, hold the trimmer head about 3 in. (7.6 cm) above the ground and at an angle. Allow the tip of the line to strike the ground cutting the vegetation off at the surface (Fig. 15). POTENTIAL HAZARD Use of improper line could cause line to break and be thrown in operator’s or bystander’s... - Page 15 Figure 20 1. Groves 8. Thread the two ends of the line through the eyelets, Figure 18 place spool into head and pull line to release from 1. Spool grooves (Figs. 21). 3. Clean the dirt from the inside of the spool parts if required.
-
Page 16: Maintenance
2. Remove the foam ring and filter screen from the air charge repairs under the terms and provisions of the filter cover (Fig. 24). Toro warranty statement, any service or emission 3. Clean the foam ring and filter screen with warm, soapy control part repair or replacement must be performed water. -
Page 17: Fuel Filter
IMPORTANT: The air filter screen is designed to fit 5. While still holding on to the fuel hose, attach the new into the air filter cover ONE WAY ONLY. Make sure fuel filter. the cutouts in the screen fit onto the matching plastic 6. -
Page 18: Spark Plug
If idle speed adjustment is necessary, and after adjustment the trimmer head rotates or the engine stalls, stop using the String Trimmer immediately! Figure 29 Contact your local authorized Toro Dealer for assistance and servicing. 1. Screw 2. Cylinder Cover... - Page 19 2. Socket Head Screw Ï Ï Ï Ï Ï Ï Ï Ï Ï Ï Model 53002 & 53003 Ï Ï Ï Ï Ï 1. With the engine at ambient (room) temperature, loosen the knob and remove the air cleaner cover (Fig. 31).
-
Page 20: Cylinder Cooling Fins
(Figs 30 and 29). after the engine is shut off. WHAT CAN HAPPEN Model 53002 & 53003 Contact with hot muffler surfaces could cause a burn. 1. With the engine at ambient (room) temperature, loosen HOW TO AVOID THE HAZARD the knob and remove the air cleaner cover (Fig. - Page 21 3. Screen 6. Muffler 5. Reinstall the muffler cover (Fig. 30). Model 53002 & 53003 1. With the engine at ambient (room) temperature, loosen the knob and remove the air cleaner cover (Fig. 33). 2. Loosen the knob and lift off the cylinder cover (Fig.
-
Page 22: Gearcase Maintenance
HOW TO AVOID THE HAZARD Always turn off your Trimmer before you clean or perform any maintenance on it. The Toro String Trimmer will provide maximum performance for many, many hours if it is maintained properly. Good maintenance includes regular checking of... -
Page 23: Accessories
Idle speed set incorrectly Set idle speed Engine Lacks Power or Stalls When Throttle wire has come loose Tighten throttle wire Cutting Cutting Dirty air filter Clean or replace air filter If further assistance is required, contact your local authorized Toro service dealer. -
Page 24: Specifications
Specifications Note: All models are CARB approved. 53010/Commercial 53002/Industrial Engine Displacement 23cc Engine Displacement 26cc Shaft Straight (59”/150 cm) Shaft Straight (59”/150 cm) steel with 5 ball steel with 6 ball bearings, 5 bushings bearings, 5 bushings Anti Vibration Dual Isolation – grip and Anti Vibration Dual Isolation –... -
Page 25: Federal And California Emission Control Warranty Statement
U.S. EPA standards for the first two years of engine use from the date of sale to the ultimate purchaser. Toro must warrant the emission control system on your utility/lawn/garden equipment engine for the period of time listed above provided there has been no abuse, neglect or improper maintenance of your utility/lawn/garden equipment engine. - Page 26 The manufacturer is not liable to cover failures of warranted parts caused by the use of add–on or modified parts. Toro is liable for damages to other engine components caused by the failure of a warranted part still under warranty. The owner is responsible for the performance of the required maintenance, as defined by the manufacturer in the written instructions.
- Page 27 The Toro Company is not liable for indirect, incidental or consequential damages in connection with the use of the TORO Products covered by this warranty, except for damages to other engine components caused by the failure of a warranted part still under warranty. Some states do not allow exclusions of incidental or consequential damages, so the above exclusion may not apply to you.
- Page 28 Pickup and delivery charges for distances beyond a 15-mile radius from a TORO ProLine Service Dealer. TORO Products used for residential use are covered by a full two-year warranty. All repairs covered by this warranty must be performed by a TORO Service Dealer using Toro approved replacement parts.