1. Manuals
  2. Brands
  3. Toro Manuals
  4. Trimmer
  5. 53008
  6. Operator's manual

Toro 53008 Operator's Manual

Commercial se series
Hide thumbs
Table of Contents

Advertisement

Quick Links

Commercial SE Series
String Trimmer
Model No. 53008 — 990001 & Up
Model No. 53009 — 990001 & Up
16" & 18" Gas
Modèle No. 51903 — 790000001 et suivants
Modèle No. 51904 — 790000001 et suivants
Modèle No. 51906 — 790000001 et suivants
Modèle No. 51907 — 790000001 et suivants
16" & 18" Gas
Modelos N. 51903 — 790000001 y siguientes
Modelos N. 51904 — 790000001 y siguientes
Modelos N. 51906 — 790000001 y siguientes
Modelos N. 51907 — 790000001 y siguientes
Operator's Manual
Manuel de l'Utilisateur
FORM NO. 3322-188 Rev. A
Manual del Usuario

Advertisement

Table of Contents
loading

Related Manuals for Toro 53008

Summary of Contents for Toro 53008

  • Page 1 FORM NO. 3322-188 Rev. A Commercial SE Series String Trimmer Model No. 53008 — 990001 & Up Model No. 53009 — 990001 & Up 16” & 18” Gas Modèle No. 51903 — 790000001 et suivants Modèle No. 51904 — 790000001 et suivants Modèle No.
  • Page 2 WARNING: The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.

  • Page 3: Table Of Contents

    ..Warranty Statement ......The Toro Company – 1998 All Rights Reserved...

  • Page 4: Introduction

    For your convenience, write the product model and serial numbers in the space below. All of us at Toro want you to be completely satisfied with your new product, so feel free to contact your local Authorized Service Dealer for help with service, genuine Toro parts, or other information you may require.

  • Page 5: String Trimmer Safety

    2. Always wear eye protection that complies with ANSI 7. Never use a cutting head or replacement parts that are (American National Standards Institute) Z87–1. not approved by Toro. 8. Maintain the String Trimmer according to the recommended maintenance intervals and procedures in the Maintenance section on page 17.

  • Page 6: Power String Trimmer Operating Safety

    11. Keep firm footing and balance. Do not overreach. 12. Use the right tool for the job. Do not use the Trimmer for any job that is not recommended by Toro. Figure 3 1. 50 ft. (15 m) Minimum...

  • Page 7: Safety And Instruction Decals

    Safety and Instruction Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. ON SHAFT (Part No. M221501) ON SHAFT (Part No. M221502)

  • Page 8: Assembly

    Assembly Loop Handle Installation 5. Reposition the loop handle up or down the drive shaft to the most comfortable position, but no closer than 9 inches (22.8 cm) from the end of the stop switch The loop handle kit contains a package of four screws and (Figs.

  • Page 9: Installing Trimmer Head Shield (Straight Shaft Model)

    Installing Trimmer Head Shield Installing Trimmer Head Shield (Straight Shaft Model) (Curved Shaft Model) POTENTIAL HAZARD POTENTIAL HAZARD The cutoff blade is sharp. The cutoff blade is sharp. WHAT CAN HAPPEN WHAT CAN HAPPEN Contact with cutoff blade could cause serious Contact with cutoff blade could cause serious cuts or personal injury.

  • Page 10: Installing Trimmer Head (Straight Shaft Model)

    Installing Trimmer Head Installing Trimmer Head (Straight Shaft Model) (Curved Shaft Model) IMPORTANT: Make sure the trimmer head is for IMPORTANT: Make sure the trimmer head is for LEFT-HAND ROTATION (counterclockwise) as RIGHT-HAND ROTATION (clockwise) as viewed from viewed from the operator’s position, and that the the operator’s position, and that the trimmer head trimmer head adapter is a male, M8 x 1.25 left-hand adapter is a female, M8 x 1.25 right-hand thread.

  • Page 11: Before Operation

    In certain conditions gasoline is extremely flammable and highly explosive. Only use a two-cycle engine oil formulated for use in high-performance, air-cooled two-cycle engines. Toro WHAT CAN HAPPEN brand 2-cycle oil is formulated for use in A fire or explosion from gasoline can burn you, high-performance, air-cooled two-cycle engines.

  • Page 12: Mixing Gasoline And Oil

    7. Always shake the premix fuel container momentarily before filling the fuel tank For your fuel premix, only use a quality oil designed for 2–cycle air cooled engines. Toro 8. Always use a spout or funnel when fueling to reduce fuel spillage.

  • Page 13: Starting And Stopping

    1. Primer Bulb 3. Choke 2. Fuel Return Line 4. Starter Handle The carburetors on Toro engines contain a choke system. To start a “cold” engine properly, perform the following procedure: 1. Pump the primer bulb at the bottom of the carburetor until fuel can be seen flowing through the fuel return line to the fuel tank (Figs.
  • Page 14 Cold Starting Procedure section above. If the engine fails to start after you follow the above procedures, contact an authorized Toro dealer. To Stop The Engine: 1. Release the throttle trigger (Fig. 12). 2. Slide the stop switch to the “STOP” position (Fig. 12).

  • Page 15: Operation

    Operation Read the Safety instructions on page 4 Always wear gloves and protective clothing concerning proper use of the String Trimmer. when operating the String Trimmer. If the trimmer head becomes jammed, stop the engine Operating Position immediately. Make certain all moving parts have stopped and Before using the Trimmer, check the following (Fig.

  • Page 16: Cutting With Nylon Trimmer Line

    Cutting with Nylon Trimmer Trimming Line Hold the bottom of the trimmer head about 3 in. (7.6 cm) above the ground and at an angle. Allow only the tip of The tip of the line does the cutting. The line should the line to make contact (Figs.

  • Page 17: Maintenance

    However, to obtain no charge repairs under the terms and provisions of the Toro warranty statement, any service or emission control part repair or replacement must be performed by an Authorized Toro Service Dealer.

  • Page 18: Air Filter

    Air Filter Spark Plug Maintenance Interval Maintenance Interval The air filter should be cleaned daily, or more often The spark plug should be removed from the engine when working in extremely dusty conditions. and checked after each 25 hours of operation. Replace after every 100 hours of operation.

  • Page 19: Fuel Filter

    Fuel Filter Maintenance Interval Î Î Î Î Î The fuel filter should be replaced after every 100 hours of operation. Î Î Î Î Î Î Î Î Î Î Fuel Filter Replacement Î Î Î Î Î Î Î Î Î Î The fuel filter is attached to the end of the fuel pick-up hose inside the fuel tank (Fig.

  • Page 20: Idle Speed Adjustment

    If idle speed adjustment is necessary, and after adjustment the trimmer head rotates or the engine stalls, stop using the String Trimmer immediately! Contact your local authorized Toro Dealer for assistance Figure 26 and servicing. 1. Muffler Cover 2.

  • Page 21: Spark Arrester

    Spark Arrester POTENTIAL HAZARD Muffler surface becomes hot when Trimmer is in operation and remains hot for some time after the engine is shut off. WHAT CAN HAPPEN Contact with hot muffler surfaces could cause a burn. HOW TO AVOID THE HAZARD Make sure the muffler is cool before inspecting and cleaning the spark arrester.

  • Page 22: Gearcase Maintenance (Straight Shaft Model Only)

    HOW TO AVOID THE HAZARD Always turn off your Trimmer before you clean or perform any maintenance on it. The Toro String Trimmer will provide maximum performance for many, many hours if it is maintained properly. Good maintenance includes regular checking of all fasteners for correct tightness, and cleaning the entire machine.
  • Page 23 7. Slowly pull the starter handle to bring the piston to the top of the cylinder (TDC). 8. Reinstall the spark plug. 9. Store the String Trimmer in a dry place away from excessive heat, sparks or open flame. Figure 29...

  • Page 24: Accessories

    Idle speed set incorrectly Set idle speed Throttle wire has come loose Tighten throttle wire Engine Lacks Power or Stalls When Cutting Cutting Dirty air filter Clean or replace air filter If further assistance is required, contact your local authorized Toro service dealer.

  • Page 25: Specifications

    Specifications Note: All models are CARB approved. 53008/Commercial 53009/Commercial Engine Displacement 22.5 cc Engine Displacement 22.5 cc Shaft Curved Shaft Shaft Straight Shaft Anti Vibration Handle Grip Anti Vibration Dual Isolation – grip and engine mount Carburetor Walbro – Choke Type Carburetor Walbro –...

  • Page 26: Federal Emission Control Warranty Statement

    The manufacturer is not liable to cover failures of warranted parts caused by the use of add–on or modified parts. Toro is liable for damages to other engine components caused by the failure of a warranted part still under warranty. The owner is responsible for the performance of the required maintenance, as defined by the manufacturer in the written instructions.
  • Page 27 Hoses, connectors, and assemblies of same How to Get Warranty Service: Should you feel your TORO Product requires warranty service, contact the dealer who sold you the product or any Authorized TORO Service Dealer or TORO Master Service Dealer. The Yellow Pages of your telephone directory is a good reference source.

  • Page 28: Warranty Statement

    What Is Covered By This Express Warranty? analysis of the defect in materials or workmanship or if you need a referral to a TORO ProLine Service Dealer, please feel free to The Toro Company promises to repair any TORO Product...

This manual is also suitable for:

53009

Table of Contents