Cub Cadet RZT-S Zero Operator's Manual page 21

Refer to the manual packed with your battery charger for
information and instructions on charging the batteries. Lift the
charging port cover up and insert the charging cord into the
charging port located in the left console. See Figure 6-1.
Charging Port Cover
Figure 6-1
Battery Charging Tips
• Use only the battery charger provided with this rider.
• The batteries should be fully charged before the each use.
• It is recommended that the rider be charged once every
month during off-season storage.
• It will take approximately 16 hours to fully charge the
batteries. Leaving the batteries connected to the charger
for more than 16 hours will not damage the batteries.
• The batteries do not develop a memory and do not need to
be fully discharged before recharging.
• Always disconnect battery charger (or extension cord, if
used) from the electrical outlet first, then disconnect the
charging cord from the charging port.
• It is recommended that the rider be charged after reach
use. Storing batteries in a discharged state could reduce
future performance.
Rider Storage
NOTE: Store rider indoors in a dry place and out of the reach of
children.
If your rider is not going to be operated for an extended period
of time (thirty days to approximately six months), the rider should
be prepared for storage. Store the rider in a dry and protected
location. If stored outside, cover the rider completely to protect
it from the elements. The procedures outlined below should be
performed whenever the rider is placed in off-season storage.
1. Clean the entire rider thoroughly.
2. Fully charge the batteries and recharge the batteries every
30 days when in storage.
Charging Port
Charging Cord
3. Lubricate all lubrication points.
NOTE: Use of a pressure washer or garden hose is not
recommended to clean your rider. This may cause
damage to electrical components and bearings. The use
of excessive water will result in shortened life and reduce
serviceability.
Removing The Rider From Storage
1. Fully charge the batteries and inflate the tires to the
recommended pressures.
2. Drive the rider without a load to make certain all the rider
systems are functioning properly.
Cleaning the Rider
A brush, damp sponge or rag should be used to clean the rider.
NOTE: Do not spray water into the battery compartment when
cleaning the rider. Doing so can cause serious damage to the
riders electrical system.
NOTE: To clean the battery cover, the seat must be positioned all
the way back to be tilted up to access the area under the seat.
Cleaning the Deck
NOTE: The deck is not removable.
Your rider's deck is equipped with a water port on its surface as
part of its deck wash system.
Use the Smart Jet™ to rinse grass clippings from the deck's
underside to prevent the buildup of corrosive chemicals.
Complete the following steps AFTER EACH MOWING:
1. Drive the rider to a level, clear spot on your lawn, close
enough for your garden hose to reach.
CAUTION:
Make certain the rider's discharge chute
is directed AWAY from your house, garage, parked
cars, etc.
2. Stop the rider, disengage the blades, set the parking brake
and turn the key switch to the OFF position.
3. Thread the hose coupler (packaged with your rider's
Operator's Manual) onto the end of your garden hose.
S 6 — M
ection
& a
aintenance djuStMentS
21