Cub Cadet RZT-S Zero Operator's Manual page 16

Starting the Rider
WARNING!
interlock system designed for the protection of the
operator. Do not operate the rider if any part of the
system is malfunctioning. Periodically check the
function of the interlock system for proper operation.
WARNING!
be sitting in the seat when starting the rider.
To start the rider follow the steps below:
NOTE: The LCD display will also walk you through the steps
necessary to start the rider. When each task is completed the
icon will change to a darkened icon on the display and advance
to the next step.
NOTE: If the task has already been completed the LCD display will
skip that step and automatically move on to the next, i.e. if you
are already in the operator's seat when you turn the key switch
on the step will not appear on the screen.
1. Unplug the charger. See Figure 5-2.
2. Sit in the rider seat. See Figure 5-3.
16 S 5— o
ection peration
This rider is equipped with a safety
For personal safety, the operator must
Figure 5-2
Figure 5-3
3. Make sure the blade start/stop knob in the DISENGAGED
position. See Figure 5-4.
Figure 5-4
4. Insert the key into the key switch and turn it to the ON
position.
NOTE: At this point you can change the language or
measurements as instructed in the Set-Up section.
5. If your foot is on the forward/reverse drive pedal, remove it.
See Figure 5-5.
Figure 5-5
6. Place foot on the brake pedal. See Figure 5-6.
Figure 5-6