Own Number Sending; Quick On-Line - Sharp AR-FX12 Service Manual

3. Own number sending

This function prints the date, time, your programmed name, your
programmed fax number, and the transmitted page number at the top
center of each page that you fax. All pages that you fax include this
information.
Example of fax page printed out by the receiving machine
OCT-10-2003-FRI 03:00 PM SHARP PLANNING DIV.
<1> <2>
<1> Date and time: The date and time, and the font used to print
the date and time, are set in the custom
settings.
<2>Own name: programmed with the key operator program.
<3>Own fax number: programmed with the key operator program.
<4> Transmitted page 3-digit number appearing in the format, "page
number: number/total pages" (only the page number
appears if you use manual transmission or
Quick On-Line transmission). If desired, you
can use the key operator program to omit the
page number.
A. Position of sender's information
The key operator program can be used to select whether the sender's
information is added outside the original data or inside the data. The
initial factory setting is outside the data.
Direction of transmission
Outside scanned data
None of the transmitted image is cut off; however, the transmitted data is
longer than the scanned data, and thus when both the sender and the
receiver use the same size of paper, the printed fax may either be
reduced or split up and printed on two pages.
Direction of transmission
Inside scanned data
The top edge of the scanned data will be cut off by the sender's
information; however, when both the sender and the receiver use the
same size of paper, the printed fax will neither be reduced nor split up
and printed on two pages.
FAX No. 0666211221 P. 001/001
<3> <4>
AR-FX12 MACHINE OPERATION 7-3

4. Quick On-line

When you use the automatic document feeder to send a multi-page
document and there are no previously stored jobs waiting or in progress
(and the line is not being used), the machine dials the destination after
the first page is scanned and begins transmitting scanned pages while
the remaining pages are being scanned. This transmission method is
called Quick On-line. The messages SCANNING ORIGINAL and
SENDING both appear until scanning of the final page is completed.
If the receiving party is busy, the transmission will switch to a memory
transmission.
NOTES
•The machine is initially set (factory setting) to perform Quick On-line
transmission. If desired, you can turn off this function with the key
operator program.
•When a document is transmitted using the following methods, the job
will be stored in memory (Quick On-line transmission will not be
performed):
<1>Sending from the document glass
<2>Broadcast transmission
<3>Timer transmission
<4>2 in 1
<5>Card shot
<6>Job build
<7>F-code transmission