Instrument Cluster Pinouts; Instrument Cluster Removal; Instrument Cluster Installation - Polaris 2013 RANGER RZR S Service Manual

6. To exit the diagnostic mode, press and hold the
MODE button or turn the ignition key OFF once the
codes are recorded.
NOTE: If there is a diagnostic problem with the
power steering system, the power steering MIL will
illuminate and blink in place of the check engine MIL.

Instrument Cluster Pinouts

FUNCTION
CAN High
CAN Low
Switched Power (Vdc)
Constant Power (Vdc)
Ground
High Beam Input
Fuel Level Sensor
International Models Only
Turn Signal Input, LH
Turn Signal Input, RH

Instrument Cluster Removal

NOTE: Do not allow alcohol or petroleum products
to come in contact with the instrument cluster lens.
1. Disconnect the wire harness connector from the back
side of the instrument cluster.
PIN
1
2
3
4
5
8
11
6
7
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
2. Push instrument cluster out from back side of the dash
while securely holding the dash and rubber mount.
Push Instrument
Cluster Outward
Bezel
NOTE: Do not remove the rubber mount from the
dash panel. Only remove the rubber mount if
necessary. The bezel is a snap-on assembly and is a
serviceable part.

Instrument Cluster Installation

1. Spray a soap and water mixture onto outer surface
area of instrument cluster. This will help the
instrument cluster slide into the rubber mount easily.
2. Be sure the rubber mount inside the dash is fully
installed and that the indexing key on the rubber
mount is lined up with the keyway in the dash.
3. Hold dash securely and insert the instrument cluster
into the dash. Twist the instrument cluster gently in a
clockwise motion to properly seat the instrument
cluster into the rubber mount. Apply pressure on the
bezel while pressing down on the instrument cluster.
ELECTRICAL
Dash Panel
Rubber Mount
Instrument Cluster
10.17
10