Control Panel; Removing The Control Panel - Dell PowerEdge FX2 Owner's Manual

5. Install the Mylar insulator.
Next steps
1. Install the midplane assembly.
2. Follow the procedure listed in

Control panel

Removing the control panel

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: This is a field replaceable unit (FRU). Removal and installation procedures must be performed
only by Dell certified service technicians.
NOTE: You must remove the control panel to replace a faulty control panel.
1. Ensure that you read the
2. Follow the procedure listed in
Steps
1. Remove the three screws that secure the cable tube to the side of the system and remove the cable
tube.
2. Remove the two screws that secure the control panel to the system.
Figure 62. Removing and installing the cable tube
1. control panel
After working inside your
Safety instructions.
Before working inside your
system.
system.
2. screw (5)
81