I/O Module Port Mapping-Six-Bay Chassis - Dell PowerEdge FX2 Owner's Manual

The following table lists the compute sleds and the ports to which they are mapped.
Table 9. I/O module port mapping in eight-bay chassis
Compute sled
1a
1b
1c
1d
3a
3b
3c
3d
I/O module port mapping—six-bay chassis
The six-bay chassis supports a combination of up to four quarter-width compute sleds and up to two
half-width compute sleds.
In the six-bay chassis, a quarter-width compute sled is mapped to one port on each I/O module. A half-
width compute sled with quad-port NDC is mapped to two ports on each I/O module.
NOTE: A half-width compute sled with dual-port NDC is mapped to a single port on each I/O
module.
NOTE: In the six-bay PowerEdge FX2s configuration that supports storage sleds mapped to quarter-
width compute sleds, the I/O module ports are mapped only to the compute sleds. If storage sleds
are installed, the corresponding ports on the I/O modules mapped to these slots are not active.
Figure 19. I/O module port mapping—six-bay chassis
The following table lists the compute sleds and the ports to which they are mapped.
28
IO Module A1 (Top)
1
2
3
4
5
6
7
8
IO Module A2 (Bottom)
1
2
3
4
5
6
7
8