Nokia IP40 User Manual page 31

Table 9
Table 9 Rear Panel of IP40
Label
Console
Reset
Note
Do not use a sharp pin or thin piece of metal to press the Reset button.
Nokia IP40 Security Platform User's Guide v1.1
explains the items on the rear panel of the Nokia IP40.
Description
The console port is a 9-pin male connector that can be
connected to the serial (COM) port of your computer.
You can then use the command-line interface (CLI) of
the IP40 through a serial program such as
HyperTerminal to communicate with the device.
Used to reboot or reset the IP40 to its factory defaults.
Use a large flat-tipped object, such as a thick paper
clip, to press the reset button.
Short press (one second): reboots the Nokia IP40
Security Platform.
Long press (seven seconds): resets the IP40 to its
factory defaults. This results in loss of all security
services and passwords.
Short press during boot up: boots the IP40 in special
deployment mode. See
Platform to Factory Defaults by Using the Reset
Button" on page 151.
"Resetting Nokia IP40 Security
Appliance Overview
31