By Using The Reset Button - Nokia IP40 User Manual

3. Click OK.
Note
Since the network settings change, you cannot access the device immediately. Release,
and renew the IP address by running the Refresh IP tool located in the tools folder on the
CDROM, and then access the IP40 GUI portal.
Resetting Nokia IP40 Security Platform to Factory Defaults

by Using the Reset Button

The Restore Defaults button is inside a hole on the back panel of Nokia IP40. To press the
button, use a large flat-tipped object, such as a thick paper clip. Pressing the Restore Defaults
button for seven seconds restores all IP40 settings back to factory defaults. The button works
only after booting is complete, and the green light must be illuminated to activate the button.
The status light goes off while defaults are being restored, and relights after defaults are restored
and the IP40 begins to reboot. It takes over two minutes to restore defaults.
An Amber light is displayed while rebooting. Until the first-time login and password are set, the
green light blinks. A blinking green states that the device is set to factory defaults.
Nokia IP40 Security Platform User's Guide v1.1
The Please Wait window appears.
The IP40 returns to its factory defaults.
The IP40 restarts.
This can take up to a minute.
The Login page reappears.
Resetting Nokia IP40 Security Platform to Factory Defaults
151