Loading Default Setup; Checking System Information - Q-See QSTD2404 User Manual

QSTD2400 Series DVR User's Manual
Notice: If a "no device" or "no file" error appears, it is possible that the USB device is
incompatible. Please try another USB flash drive.
Please be patient. It will take 2-3 minutes to update.

5.3 Loading Default Setup

The DVR has different setup blocks, like Basic, Record, Schedule, Motion etc.
Users can choose any block to restore default setup, see Fig 5.2 Reset Blocks.
STEP1 Enter TOOLS configuration, refer to 4.2.10 Tools Configuration.
STEP2 Click Load default. Select setup blocks; please refer to Fig 5.2 Reset
Blocks.
STEP3 Press OK to reset to default. It will return to TOOLS interface when
finished.

5.4 Checking System Information

To check system information like firmware version, IP address, etc.
STEP1 Press right mouse button to show the control bar. Click Menu, refer
to Fig 4.2 Pop up Menu.
STEP2 Click Info, the window below will appear.
Fig 5.2 Reset Blocks
Fig 5.3 Status Interface
39