Load Default Setup; Check System Information - Q-See QSDT8DP User Manual

STEP5 After finishing, the unit needs to be restarted.
Note: If a "no device or no file" error appears, it is possible that the USB device is
incompatible. Please try a different USB flash drive.
Please be patient. It will take 2-3 minutes to update.

5.3 Load Default Setup

The DVR has different setup blocks, like Basic, Record, Schedule, Motion
etc. Users can choose any block to do default, as shown in Fig 5.2 Reset
Blocks.
STEP1 Enter TOOLS configuration, referring to 4.2.10 Tools
Configuration.
STEP2 Click Load default. Select setup blocks; please refer to Fig 5.2
Reset Blocks.
STEP3 Press OK to do default. It will return to TOOLS interface after
finished.

5.4 Check System Information

Users can check system information like firmware version, IP address and
etc.
STEP1 Press right mouse button to show the control bar. Click Menu;
refer to Fig 4.2 Pop up Menu.
STEP2 Click Info, the window below will appear.
QSDT8DP DVR User's Manual
Fig 5.2 Reset Blocks
41