Table of Contents
Advertisement
Removal
Remove the memory board as follows:
IMPORTANT:
The memory board is extremely sensitive to static electricity. Make sure to touch the
metal frame of the server to discharge static electricity from your body before handling
the memory board. Do not touch the memory board terminals or on-board parts by a
bare hand or place the memory board directly on the desk. For static notes, see the
section "Anti-static Measures" described earlier.
The memory board becomes very hot while being powered. When removing the board,
turn off the power and wait for several minutes before pulling it out.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Unlock the front door with the security key, and open the front door.
3.
Remove the two screws, and remove the memory slot cover from the front of the server.
4.
Unlock the memory board to open the ejector.
The memory board becomes very hot while being powered. When removing the board, turn off the power and
wait for several minutes before pulling it out.
Note that the hot-plug memory board is off-powered when it is unlocked (the LED goes off). Wait several
minutes in this state.
9-43
Advertisement
Table of Contents
