NEC 140He User Manual page 105

Menu
+Fail Drive
+Make HotSpare
+View Drive Information
• Device Type
• Capacity
• Vender ID
• Product ID
• Revision
• SCSI Standard
• Media Errors
• Other Errors
*16 Synchronous Negotiation
*17 SCSI Command Q Tagging
+Channel
+Channels
*18 Termination State
*19 Enable Auto Termination
*20 SCSI Transfer rate
+Format
+Rebuild
+Check Consistency
+Select Adapter
Setting values
No. Setting parameter
*1 FlexRAID PowerFail
*2 Fast Initialization
*3 Disk Spin-up Timing
*4 Cache Flush Timing
*5 Rebuild Rate
*6 Alarm Control
*7 Disable(Enable) BIOS
*8 Emulation
*9 Auto Rebuild
*10 Cluster Mode
*11 Multiple PCI Delayed Trans
*12 Force Boot
*13 Coercion Algorithm
*14 CC Restoration
*15 Temporary Offline RAID
*16 Synchronous Negotiation
*17 SCSI Command Q Tagging
*18 Termination State
*19 Enable Auto Termination
*20 SCSI Transfer rate
Changing factory settings
The settings for the following items can be changed. Follow each explanation:
*2 Fast Initialization
*5 Rebuild Rate
*14 CC Restoration
Description
Set the disk offline
Set as stand-by disk for auto rebuilding
Display hard disk information
Hard disk type
Hard disk capacity
Hard disk vender name
Hard disk model
Hard disk revision
SCSI standard
The number of media errors
The number of other errors
SCSI synchronous negotiation
Set SCSI command Q Tag
Set channel
Chose SCSI channel
Set termination state
Set auto termination state
Set transfer rate
Perform low level format
Perform rebuilding
Perform logical drive redundancy check
Select disk array controller
* This menu item does not appear if no disk array controller is installed
in the computer.
Factory setting
ENABLED
ON
2 disks every 6 secs
Every 4 Seconds
30%
Disable Alarm
Enable (Display: Disable BIOS)
MASS STORAGE
ENABLED
DISABLED
ENABLED
ON
NONE
ENABLED
ENABLED
Enabled
Enhanced QTAG Scheduling
Enabled
No
320M
A setting of "On" is recommended.
This initializes the top area of the disk only.
A setting of "30%" is recommended.
Factory setting is "ENABLED".
*Do not use
Setting change
Do not change
Variable setting
Do not change
Do not change
Variable setting
Do not change
Do not change
Do not change
Do not change
Do not change
Do not change
Do not change
Do not change
Variable setting
Do not change
Do not change
Do not change
Do not change
Do not change
Do not change
4-33