NEC 140He User Manual page 104

4-32
Menu
+Adapter
+Clear Configuration
*1 FlexRAID PowerFail
*2 Fast Initialization
*3 Disk Spin up Timing
*4 Cache Flush Timing
*5 Rebuild Rate
*6 Alarm Control
+Other Adapter Information
• FW Supports
• FW Ver
• BIOS Ver
• DRAM
• Adapter Type
+Factory Default
*7 Disable (Enable) BIOS
+Battery Information
• Backup Module
• Battery Pack
• Temperature
• Voltage
• Fast Charging
• No of Cycles
+Reset Battery Charge Counter
+Other Adapter Options
*8 Emulation
*9 Auto Rebuild
• Initiator ID
*10 Cluster Mode
*11 Multiple PCI Delayed Trans
*12 Force Boot
*13 Coercion Algorithm
Abort BI & CC Activities
*14 CC Restoration
*15 Temporary Offline RAID
+Logical Drive
+Logical Drives
+Initialize
+Check Consistency
+View/Update Parameters
• RAID
• SIZE
• Stripe SIZE
+√ Write Policy
+√ Read Policy
+√ Cache Policy
+√ FlexRAID Virtual Sizing
• #Stripes
• State
+Physical Drive
+Physical Drive Selection Menu
+Rebuild
+Format
+Make Online
Description
Set disk array controller
Clear configuration
Set whether to restart after rebuilding
Set high-speed initialization
Set hard disk spin-up
Set cache flush timing
Set rebuild rate
Set alarm sound (ON / OFF)
Board information display (FW version, etc.)
FW type
FW version
BIOS version
Memory capacity
Board series NO.
Set default value
Set BIOS Enable / Disable
Battery information
Existence of battery module
Existence of battery pack
Battery temperature
Battery voltage
Set fast charging status
The number charge cycle
Clear battery charge counter
Adapter detailed options
Set control mode
Set auto rebuilding Enable / Disable
Indicate Initiator ID No.
Set cluster mode
Set PCI bus bridge
Forced setting of configuration information(HDD)
Setting parameter for maximum hard disk capacity
Abort Background initialize or Check Consistency
Select CC Restoration mode
Set Temporary offline Enable / Disable
Logical drive operation
Select logical drive
Initialize logical drive
Check logical drive redundancy
Display logical drive information
Display RAID level
Display logical drive capacity
Display stripe size
Set write mode
Set read mode
Set cache mode
Set virtual sizing Enable / Disable *Do not set to Enable
Display stripe size
Display logical drive status
Physical drive menu
Physical drive operation
Perform rebuilding
Perform low level format
Set the disk online
*Do not use