Table of Contents
Advertisement
8-44
Error Message during Disk Array Configuration
Refer to the manual that comes with the disk array controller for any trouble occurred on disk array in this system.
The operating system cannot be installed:
•
Is configuration of the disk array controller performed?
→ Perform configuration properly by using MegaRAID Configuration Utility.
The operating system cannot be started:
•
Is the BIOS setting for the disk array controller changed?
→ Set it properly by using MegaRAID Configuration Utility.
•
Does POST recognize the disk array controller?
→ Check that the disk array controller is connected correctly and then turn the power ON.
→ When the disk array is connected correctly but is not recognized, it may be faulty. Contact the
maintenance service agent that you are contracted with or the dealer that you purchased this controller
from.
Rebuilding cannot be performed:
•
Is the capacity of the hard disk to be rebuilt insufficient?
→ Use a hard disk of the same capacity as the faulty one.
•
Is the RAID configuration RAID0?
→ RAID0 does not have redundancy thus rebuilding cannot be performed. Replace the "DEAD" hard
disk, create configuration information again, perform initialization and then restore using the backup
data.
Auto-rebuild cannot be performed:
•
Is the interval enough when hot swap are executed?
→ Take interval more than 90 seconds when hot swap are executed.
•
Is the BIOS setting for the disk array controller correct?
→ Check the BIOS setting for disk array controller by using MegaRAID Configuration Utility. Select
"Objects" → "Adapter" → "Auto Rebuild" from the TOP menu.
A hard disk goes into "FAIL" status:
→ Contact the maintenance service agent that you are contracted with or the dealer that you purchased it
from.
Advertisement
Table of Contents
