User Preferences Parameter Defaults - Motorola PL3307 Integration Manual

User Preferences Parameter Defaults

Table 4-1 lists defaults for user preferences parameters. To change any parameter value, scan the appropriate
bar code(s) provided in the User Preferences section beginning on
NOTE See
miscellaneous default parameters.
User Preferences Default Table
Table 4-1
User Preferences
Set Default Parameter
Parameter Scanning
Lock Parameter Scanning
Unlock Parameter Scanning
User Parameter Pass Through
Beep After Good Decode
Beeper Tone
Beeper Volume
Beeper Duration
Suppress Power-up Beeps
Decode LED Behavior
Decode Blinks
Decode Blink Duration
Trigger Modes
Power Mode
Time Delay to Low Power Mode
Picklist Mode
Decode Session Timeout
Timeout Between Decodes, Same Symbol
Timeout Between Decodes, Different Symbols
Continuous Bar Code Read
Appendix A, Standard Default Parameters
Parameter
User Preferences & Miscellaneous Options
page 4-5.
for all user preferences, hosts, symbologies, and
Parameter
Default
Number
Restore Defaults
ECh Enable
F2h 22h Disable
F2h 23h Disable
F1h 71h Disable
38h Enable
91h Medium
8Ch High
F1h 74h Medium
F1h D1h Do not suppress
F1h E8h Power down after LED
shuts off
F2h 5Bh Disable
F2h 5Ch Timeout Between
Decodes, Different
Symbols value
8Ah Level
80h Low Power
92h 1.0 Sec
F0h 92h Disabled Always
88h 9.9 Sec
89h 0.6 Sec
90h 0.2 Sec
F1h 89h Disable
4 - 3
Page
Number
4-5
4-6
4-7
4-7
4-8
4-9
4-10
4-11
4-12
4-12
4-13
4-14
4-15
4-16
4-17
4-17
4-19
4-19
4-20
4-20
4-21