Changing Default Values; Scanning Sequence Examples; Errors While Scanning - Motorola PL3307 Integration Manual

4 - 2 PL3307 Decoder Integration Guide

Changing Default Values

The decoder ships with the settings shown in the
Default Parameters
programming is not necessary.
There are two ways to change a parameter value:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory.
•
For SSI and USB SNAPI hosts, send a "parameter send" command from the host system. Hexadecimal
parameter numbers appear in this chapter below the parameter title, and options appear in parenthesis
beneath the accompanying bar codes. See the Simple Serial Interface (SSI) Programmer's Guide for
detailed instructions for changing parameter values using this method.
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where you can see the bar code clearly, and
bars and/or spaces are not merging.
To return all features to default values, scan
code menus, asterisks (
*
Indicates Default

Scanning Sequence Examples

In most cases, scanning one bar code sets the parameter value. For example, to set the beeper tone to high,
scan the High Frequency (beeper tone) bar code listed under
a fast warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters, such as Serial Response Time-Out or Data Transmission Formats , require scanning
several bar codes. See these parameter descriptions for this procedure.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
for all host and miscellaneous defaults). If the default values suit requirements,
*Restore Defaults on page
*
) indicate default values.
*
High Volume
(00h)
Table 4-1 on page 4-3 (also see
4-5. Throughout the programming bar
Feature/Option
Option Hex Value for programming
via SSI command
Beeper Tone on page
Appendix A, Standard
4-10. The decoder issues