GE CS5500 Programming Manual page 75

Term
SMS Format
SMS Service Center
Address
Software Revision
Sound
Sound On
Sounder Alert
Sounders
Sounds
Sounds On
Speaker Lockout
Speed
Split/multiple reports
Start Learning
Start Programming
Start Zone
Start/End Programming A menu option that causes reports to be sent to a specified phone number. A
Status Check
Store Comms Event
Summer/Winter Time
Supervised
Definition
A menu option that specifies the SMS format used for reporting with the GSM
module. The SMS format can be: Separate Events, Combined events, or SIA with
Area Modifiers.
See the GSM Module Installation Manual (CS7001) for more information.
A menu option that specifies the address of the service centre to which the
CS7001 GSM module sends SMS messages.
A menu option that displays the current software version of the selected
component.
A menu entry that groups sounder characteristics for a particular zone type.
These characteristics determine the sounds produced by the sirens and keypads
when the selected zone is activated.
A menu entry that groups the events that activate the keypad sounder.
A menu option that activates the keypad buzzer when a user arms the system with
one or more zones bypassed.
A menu entry that groups timers for the internal siren, external siren and chime
duration on the keypad.
A menu entry that groups sounder characteristics for the current keypad. It
defines the events that activate the keypad buzzer.
A menu entry that groups events that activate the internal siren.
A menu option that prevents the central station turning on the speaker at the
premises if a duress, silent panic or hold-up alarm is reported by the control panel.
A menu option that sets the data communications speed from the computer to the
control panel. This can be set from 600 baud to 76.8k baud. It is recommended to
use the default setting of 9600 baud. (System Settings)
A menu option that sets the data communications speed from the CS586 direct
connect module to the control panel. This can be set from 600 baud to 76.8k baud.
It is recommended to use the default setting of 9600 baud. (CS586 Direct Connect
Module)
The CSx75 can be configured to report events to one or more phone numbers.
Each phone number has an event selector to program which events are reported
to each number.
See Setting up a communicator in the CS5500 Programming Manual for more
information.
A menu command that triggers the learn-in mode.
See the Installation Manual for more information.
A menu entry that groups the reporting codes sent to the central station when
programming starts.
A menu option that specifies the first zone number of zones on the RF receiver.
report is sent when local programming begins and ends.
A menu option that allows the end-user to verify the system status using a touch
phone. This option enables level 7. (CS534 Listen-in Module)
A menu entry that groups the status indicators for GSM events. (CS7001 GSM
Module)
A menu command that allows a device connected to the serial port to send reports
to the central station using the controls modem.
A menu option that allows automatic switching of summer and winter time.
A menu option that enables supervision of the selected RF sensor.