Toro Groundsmaster 4000-D Service Manual page 233

B. Make sure that ignition switch is OFF and discon-
nect the switch connector from wire harness.
C. Using a multimeter, verify that wire harness con-
nector terminal for pink wire has 12 VDC when the
ignition switch is ON.
D. Make sure that clearance between end of posi-
tion switch and sensing plate is from 0.070" and
0.130" (1.8 to 3.3 mm). If necessary, adjust position
switch (see Cutting Deck Position Switches in the
Adjustments section of this chapter). Recheck
switch operation after adjustment.
E. If pink wire has system voltage present and gap is
correct but switch LED did not function, replace posi-
tion switch.
6. After testing is complete, make sure that position
switch connector is plugged into wire harness.
Groundsmaster 4000--D/4010--D
3
1. Side position switch
2. Sensing plate
Page 5 - - 45
1
Figure 61
3. Switch LED location
Electrical System
2