Bosch VEZ-400 Series Installation Manual
Autodome 4000 mini ptz dome
Hide thumbs
Also See for VEZ-400 Series:
- Operation manual (90 pages) ,
- Installation manual (36 pages) ,
- Operation manual (78 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Bosch VEZ-400 Series
Summary of Contents for Bosch VEZ-400 Series
- Page 1 AUTODOME 4000 Mini PTZ Dome VEZ-400 Series Installation Manual...
-
Page 3: Table Of Contents
Typical Wiring Configuration RS-485 Connections Video Connection Alarm Connections Power Connections Camera Settings 5.6.1 Setting the address (ID) of the camera 5.6.2 Setting the protocol of the camera Troubleshooting Technical data Bosch Security Systems, Inc. Installation Manual 2015.08 | | Recessed Mount... -
Page 4: Safety En
Legal Information Copyright This manual is the intellectual property of Bosch Security Systems, Inc. and is protected by copyright. All rights reserved. Trademarks All hardware and software product names used in this document are likely to be registered trademarks and must be treated accordingly. - Page 5 (rain, snow, etc.); liquid has been spilled in or on the equipment; Bosch Security Systems, Inc. Installation Manual 2015.08 | | Recessed Mount...
-
Page 6: Important Notices
16. Attachments, changes or modifications - Only use attachments/accessories specified by the manufacturer. Any change or modification of the equipment, not expressly approved by Bosch, could void the warranty or, in the case of an authorization agreement, authority to operate the equipment. - Page 7 Video loss - Video loss is inherent to digital video recording; therefore, Bosch Security Systems cannot be held liable for any damage that results from missing video information.
-
Page 8: Customer Support And Service
| Safety EN AUTODOME 4000 Mini PTZ Dome Customer Support and Service If this unit needs service, contact the nearest Bosch Security Systems Service Center for authorization to return and shipping instructions. Service Centers Telephone: 800-366-2283 or 585-340-4162 Fax: 800-366-1329 Email: cctv.repair@us.bosch.com... -
Page 9: Unpacking
Verify that all the parts listed in the Parts List below are included. If any items are missing, notify your Bosch Security Systems Sales or Customer Service Representative. – Do not use this product if any component appears to be damaged. Please contact Bosch Security Systems in the event of damaged goods. –... -
Page 10: Additional Tools Required
Additional Tools Required – No. 2 Phillips screwdriver – Drill with appropriate bit for pre-drilling anchor holes – Appropriate tool for cutting a hole in drywall or ceiling tile (if applicable) 2015.08 | | Recessed Mount Installation Manual Bosch Security Systems, Inc. -
Page 11: Installation Overview
VEZ-A4-PC AUTODOME 4000 Pipe where the camera is mounted to mount a horizontal (high) ceiling (Charcoal color) AUTODOME 4000 Pipe VEZ-A4-PW mount (White color) Bosch Security Systems, Inc. Installation Manual 2015.08 | | Recessed Mount... -
Page 12: Dimensions
Electrical Code (NEC)), Canadian Electrical Code, Part I (also called CE Code or CSA C22.1), ® and all applicable local codes. Bosch Security Systems, Inc. accepts no liability for any damages or losses caused by incorrect or improper installation. Dimensions Ø112... -
Page 13: Installing A Recessed Mount (Autodome 4000)
Determine a secure location for the recessed mount (supplied separately). Figure 4.1: Recess Mount Dimensions Drill or cut a 7 in. hole with a tolerance of +/- 1/8 in. (177.8 mm +/- 2.2 mm). Bosch Security Systems, Inc. Installation Manual 2015.08 | | Recessed Mount... - Page 14 41.7 mm (1.64 in.) maximum ceiling thickness and 12.7 mm (0.50 in.) minimum ceiling thickness). Figure 4.3: Attach Recess Mount to Ceiling 2015.08 | | Recessed Mount Installation Manual Bosch Security Systems, Inc.
- Page 15 Over torquing the ceiling clamps can damage the clamp or ceiling. Only tighten the clamp until it contacts the ceiling and you start to feel some resistance. If using a power screwdriver, set the torque level to the lowest setting. Bosch Security Systems, Inc. Installation Manual 2015.08 | | Recessed Mount...
-
Page 16: Installing The Camera To The Recess Mount
Attach the camera base and make the necessary DIP switch settings, and then install the bubble. (See the camera User Manual for details.) 2015.08 | | Recessed Mount Installation Manual Bosch Security Systems, Inc. - Page 17 Align the two mounting screws attached to the trim ring (item 2, below) with the two mounting holes in the recess mount. Bosch Security Systems, Inc. Installation Manual 2015.08 | | Recessed Mount...
- Page 18 Align the mounting screws with the mounting holes in the recess mount. Fit the plastic trim ring. Use the supplied T-10 Torx wrench to secure the trim ring’s two (2) safety locking screws to the mounting bracket. 2015.08 | | Recessed Mount Installation Manual Bosch Security Systems, Inc.
-
Page 19: Connection
All wires for installation applications must be routed through a grounded conduit. Caution! To prevent humidity problems, the camera must be installed in dry conditions, and the cable leads should be sealed once connected. Bosch Security Systems, Inc. Installation Manual 2015.08 | | Recessed Mount... -
Page 20: Typical Wiring Configuration
Video In to monitor (Male BNC connector) CCTV Monitor Bosch keyboard controller Note: The box around several objects in the graphic above indicates that those devices are supplied separately. 2015.08 | | Recessed Mount Installation Manual Bosch Security Systems, Inc. -
Page 21: Rs-485 Connections
The total length of the cable for communication should not exceed 1 km (3937 ft). If the distance between the camera and the control room is greater than 1 km (3937 ft), Bosch recommends using a repeater (not supplied). -
Page 22: Video Connection
Use the following tables to connect alarm wires to the 3-pin and to the 5-pin terminal blocks from the camera: Number Signal Color Yellow Orange Green Table 5.4: 3-pin Terminal Block Connections Number Signal Color Blue GND ALM Black Violet 2015.08 | | Recessed Mount Installation Manual Bosch Security Systems, Inc. -
Page 23: Power Connections
When (re)mounting the dome cover to the camera base, ensure that each screw has a rubber O-ring, and that the large rubber O-ring is in place on the camera base. This ensures protection against water ingress. Bosch Security Systems, Inc. Installation Manual 2015.08 | | Recessed Mount... -
Page 24: Setting The Address (Id) Of The Camera
Set the protocol setting, the baud rate, and the termination setting of dip switch SW303, using the data in the tables below. Note: The value marked * is the default setting. 2015.08 | | Recessed Mount Installation Manual Bosch Security Systems, Inc. - Page 25 Notice! When the RS-485 signal is looped through, make sure that (only) the last device is properly terminated. Improper RS-485 wiring or termination may result in unreliable system operation. Bosch Security Systems, Inc. Installation Manual 2015.08 | | Recessed Mount...
-
Page 26: Troubleshooting
- Check to see if the camera faces directly into the sun or a screen flickers. fluorescent lamp. If so, reposition the dome. - Check for flickers on the screen. 2015.08 | | Recessed Mount Installation Manual Bosch Security Systems, Inc. - Page 27 I see only one with the same priority number are triggered simultaneously, the triggered. system gives higher priority to the alarm with the smaller number, and handles only that alarm. Bosch Security Systems, Inc. Installation Manual 2015.08 | | Recessed Mount...
-
Page 28: Technical Data
AUTODOME 4000 Mini PTZ Dome Technical data For product specifications, see the datasheet for your camera, available on the appropriate product pages of the Online Product Catalog at www.boschsecurity.com. 2015.08 | | Recessed Mount Installation Manual Bosch Security Systems, Inc. - Page 30 Bosch Security Systems, Inc. 1706 Hempstead Road Bosch Sicherheitssysteme GmbH Lancaster, PA, 17601 Robert-Bosch-Ring 5 85630 Grasbrunn www.boschsecurity.com Germany © Bosch Security Systems, Inc., 2016 www.boschsecurity.com...