Motorola Communications Gateway User Manual page 22

Introduction Before You Begin
Then rotate the battery
Home Print
Installation & Configuration
Cabling and Startup for a Single User, continued
14
First, slide the battery
under the hook
15
16
under the snaps
X
Exit
Troubleshooting
On a slight angle, gently slide the top-right corner of the battery under the battery
hook as shown at left.
While you rotate the battery into position, to avoid pinching the wires between the
battery and the base, be sure the battery wires are not under the battery. Pinching
the wires between the battery and the base:
May damage the wires
I
Will cause the battery to seat incorrectly
I
Rotate the battery into position under the battery snaps as shown by the arrow at left.
When the battery is fully seated, the snaps engage the battery base.
Carefully replace the battery compartment cover. Do not force the cover closed. If
the battery compartment cover does not close easily, check that:
The power cord is positioned correctly in its opening
I
The battery is correctly seated (you performed steps 14 to 15 correctly)
I
17
FAQ Glossary
Communications Gateway User Guide
License