Table of Contents
Advertisement
DRX-2
Video routing paths (NAFTA)
Path ID
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
23
24
62
Description
No Routing.
Input signal is from FRONT VIDEO(CVBS) IN and will be routed to the digital board.This
routing is same as the above path id.
Input signal is from REAR VIDEO(CVBS) IN and will be routed to the digital board.
Input signal is from FRONT S-VIDEO(Y/C) IN and the signal received will be routed to the
digital board.
Input signal is from REAR S-VIDEO(Y/C) IN and will be routed to the digital board.
No Routing.
No routing.
No routing.
Input signal is VIDEO(CVBS) from TUNER and will be routed to Y Pin of Rear Y/C Connector.
This will give only black/White Picture .
Input signal is from YUV IN and will be routed to YUV OUT.This is possible only if Digital
Board routes back YUV signal received back to the Analog board(DENC)
No routing.
No routing.
No Routing.
No Routing.
No Routing.
Input CVBS Signal from Tuner is routed to Digital Board..
No Routing.
No Routing.
Input Signal from CVBS Rear In is routed to Digital Board. This is the same as path ID 02.
Input Y/C signal from Digital Board is routed to Y/C Rear Out Connector and Input signal from
Y/C Front In Connector is routed to Y/C Digital Board.
Y/C signal from Digital Board is routed to Y/C Rear Out Connector and Input signal from Y/ C
Rear In Connector is routed to Y/C Digital Board.
The Video signal received from the Digital board will be output on Modulator channel 3.
The Video signal received from the Digital board will be output on Modulator channel 4.
Advertisement
Table of Contents
