Pre-Installation Checks; Checking The Installation Environment; Check The Unit, Accessories, And Items Required For Installation; Check The Heater Settings And Air Speed Settings - Mitsubishi Electric Jet Towel JT-SB116JH-G-NA Installation Manual

Pre-installation checks

■ Checking the installation environment

Do not install in the following types of location.
(This may cause malfunctions.)
Outdoors Locations where the temperature could be lower than 50ºF (10ºC).
dust. Locations where the temperature could be higher than 104ºF (40ºC).
condensation. Locations where salt damage may occur.
Locations where the unit is in direct or strong sunlight. (May cause the sensor to malfunction.)
Near food or tableware.
(Where there is a risk of water splashing.)
Locations where corrosive, neutral, or reductive gases are present.
(This may shorten the working life of the unit and/or cause malfunctions.)
Rooms that have a sterilization basin, swimming pools, bathrooms.

■ Check the unit, accessories, and items required for installation

Product
Main unit
Required items
Screwdriver
Longer than 6" (150mm)
■ Prepare if required
AWG #12 or #14 solid or
stranded copper wire
※ Not needed if the
internal wiring is
complete

■ Check the heater settings and air speed settings

Check the heater ON/OFF settings and air speed HIGH/STANDARD settings with the customer beforehand.
(The customer cannot adjust the settings after installation is complete.)
Locations where the unit may come into direct contact with water.
Drain tank
Air fi lter
Pen
To mark position to insert metal
screw plugs in the wall
SCREW ANCHOR...7
※ Use on concrete walls
Vehicles (including ships and airplanes)
Mounting screws (5 x 30 Type 1 tapping screws)... 7
Back panel......... 1
− 3 −
Locations where there is a lot of
Locations where there is a lot of
Kitchens
Accessories
Green striped
bonding wire
Wall reinforcement
※ Reinforces walls made
of materials other than
concrete