Pre-installation checks
Warning
Single-phase 220 – 240V AC
Using the incorrect power supply may cause fi res, electric shocks or malfunctions.
■ Checking the installation environment
Do not install the unit in the following types of locations.
(This may cause malfunctions.)
Outdoors
Locations where the temperature could be lower than 0 C.
Locations where there is a lot of dust.
Locations where there is a lot of condensation.
Locations where the unit is in direct or strong sunlight (may cause the sensor to malfunction).
In vehicles (including ships and airplanes)
Locations where corrosive, neutral or reductive gasses are present.
(This may shorten the working life of the unit and/or cause malfunctions.)
Near food or tableware
Kitchens
(Where there is a risk of water splashing.)
Rooms that have a sterilization basin, swimming pools and baths.
■ Checking the unit, accessories and items required for installation
Unit
※ Shaded areas in the fi gure indicate antibacterial material (excluding outlet nozzle areas).
Main unit
Lid
Drain tank
Required items
Screwdriver
■ Prepare if required
Single wire for internal wiring
(Cable core: between 2.0mm² and 3.0mm²)
※ Not needed if the internal wiring is
complete.
power is used.
Locations where the temperature could be higher than 40 C.
Locations where the unit may come into direct contact with water.
How to open/close the front cover
(refer to Page 11)
Air fi lter
Open
Front cover
Pen
※ To mark position to insert metal
screw plugs in the wall.
Screw anchor
※ Use on concrete walls
− 3 −
Locations where salt damage may occur.
6
Accessories
Mounting screws
(5×30 Type 1 tapping screws)
Installation panel
Cord clip mounting screw
(4×14)
Cord clip
Wall reinforcement
※ Reinforces walls made of
materials other than concrete.
6
1
1
1