Table of Contents
Advertisement
3 AWARD BIOS SETUP UTILITY
Save & Exit Setup
When all the changes have been made, highlight "Save & Exit Setup" and
press <Enter>. The message shown below will appear:
Type "Y" and press <Enter>. The modifications you have made will be written
into the CMOS memory, and the system will reboot. You will once again see
the initial diagnostics on the screen. If you wish to make additional changes to
the setup, press <Ctrl> <Alt> <Esc> simultaneously or <Del> after memory
testing is done.
Exit Without Saving
When you do not want to save the changes you have made, highlight "Exit
Without Saving" and press <Enter>. The message below will appear:
Type "Y" and press <Enter>. The system will reboot and you will once again
see the initial diagnostics on the screen. If you wish to make any changes to
the setup, press <Ctrl> <Alt> <Esc> simultaneously or <Del> after memory
testing is done.
Updating the BIOS
To update the BIOS, you will need the new BIOS file and a flash utility,
AWDFLASH.EXE. You can download them from DFI's web site or contact
technical support.
38
Save to CMOS and Exit (Y/N)? N
Quit Without Saving (Y/N)? N
1.
Save the BIOS along with the flash utility AWDFLASH.EXE to a floppy
disk.
2.
Insert the floppy disk into a floppy disk drive and power-on the
system. Press the <Alt> and <F2> keys simultaneously. The utility,
which works only in DOS mode, will update the new BIOS file to the
programmable flash EEPROM that is on the system board. The new
BIOS will permanently replace the original BIOS content after flashing.
MC Series Computer Products
MAN-0CM33-001
Advertisement
Table of Contents
