Mitsubishi Electric CM33-TL User Manual page 35

V/H SYNC + Blank This will cause the system to turn off the vertical and
Blank Screen
DPMS Support
MODEM Use IRQ
This field is used to set an IRQ channel for the modem installed in your sys-
tem.
Soft-Off by PWRBTN
This field allows you to select the method of powering off your system.
Delay 4 Sec.
Instant-Off
PWR Lost Resume State
Keep Off
Turn On
Last State
Resume Time (hh:mm:ss)
This is used to set the time you would like the system to power-on. If you want
the system to power-on everyday as set in the "Date (of Month)" field, the time
set in this field must be later than the time of the RTC set in the Standard
CMOS Features submenu.
MAN-0CM33-001
3 AWARD BIOS SETUP UTILITY
horizontal synchronization ports and write blanks to the
video buffer.
This only writes blanks to the video buffer.
Initializes display power management signaling. Select
this if your video board supports it.
Regardless of whether the Power Management field is
enabled or disabled, if the power button is pushed and
released in less than 4 sec., the system enters the Suspend
mode. The purpose of this function is to prevent the system
from powering off in case you accidentally "hit" or pushed
the power button. Push and release again in less than 4
sec. to restore. Pushing the power button for more than 4
seconds will power off the system.
Pressing then releasing the power button at once will
immediately power off your system.
When power returns after an AC power failure, the system's
power is off. You must press the Power button to power-on
the system.
When power returns after an AC power failure, the system
will automatically power-on.
When power returns after an AC power failure, the system
will return to the state where you left off before power failure
occurred. If the system's power is off when AC power failure
occurred, it will remain off when power returns. If the system's
power is on when AC power failure occurs, the system will
power-on when power returns.
MC Series Computer Products
31