Yamaha 2009 XP500Y TMAX Service Manual page 46

Item
Secondary sheave nut
Crankshaft right end bearing re-
tainer screw
Secondary shaft bearing retainer
bolt
Stator coil bolt
Crankshaft position sensor bolt
Starter motor bolt
Starter motor insulator nut
O sensor
2
Coolant temperature sensor
TIP
Cylinder head stud bolt
The tightening torque is for reference only. Install the cylinder head stud bolt so that it protrudes 151.1–
151.3 mm (5.95–5.96 in) from the crankcase.
TIP
Connecting rod nut
Tighten the connecting rod nuts to 16 Nm (1.6 m·kg, 11 ft·lb), and then tighten them further to reach the
specified angle 90°.
TIP
Generator rotor nut
Tighten the generator rotor nuts to 65 Nm (6.5 m·kg, 47 ft·lb), and then tighten them further to reach the
specified angle 120°.
Thread
Q'ty
size
M18 1 90 Nm (9.0 m·kg, 65 ft·lb)
M6 1 11 Nm (1.1 m·kg, 8.0 ft·lb)
M6 2 12 Nm (1.2 m·kg, 8.7 ft·lb)
M6 3 10 Nm (1.0 m·kg, 7.2 ft·lb)
M5 2 7 Nm (0.7 m·kg, 5.1 ft·lb)
M6 2 10 Nm (1.0 m·kg, 7.2 ft·lb)
M6 1 11 Nm (1.1 m·kg, 8.0 ft·lb)
M18 1 45 Nm (4.5 m·kg, 32 ft·lb)
M12 1 18 Nm (1.8 m·kg, 13 ft·lb)
2-19
TIGHTENING TORQUES
Tightening torque Remarks
BEL-RAY
assem-
bly lube®
LT
LT
LT
LT