Checking The Lean Angle Sensor; Checking The Starter Motor Operation - Yamaha 2009 XP500Y TMAX Service Manual

Table of Contents

Advertisement

2. Check:
• Crankshaft position sensor resistance
Out of specification → Replace the crank-
shaft position sensor/stator assembly.
Crankshaft position sensor resis-
tance
189–231 Ω at 20 °C (68 °F)
M
MMM
M MMM
M
M MMM
M
M MMM
M
a. Connect the pocket tester (Ω × 100) to the
crankshaft position sensor coupler as shown.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe →
gray "1"
• Negative tester probe →
black "2"
b. Measure the crankshaft position sensor re-
sistance.
L
LLL
L LLL
L
L LLL
L
L LLL
L
EAS28130

CHECKING THE LEAN ANGLE SENSOR

1. Remove:
• Lean angle sensor
2. Check:
• Lean angle sensor output voltage
Out of specification → Replace.
Lean angle sensor output voltage
Less than 45°: 0.4–1.4 V
More than 45°: 3.7–4.4 V
M
MMM
M MMM
M
M MMM
M
M MMM
M
a. Connect the lean angle sensor coupler to the
wire harness.
b. Connect the pocket tester (DC 20 V) to the
lean angle sensor coupler as shown.
M MMM
M
M MMM
M
MMM
L LLL
L
L LLL
L
LLL
M MMM
M
M MMM
M
MMM
8-73
ELECTRICAL COMPONENTS
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe →
yellow/green "1"
• Negative tester probe →
black/blue "2"
45 ˚
45 ˚
c. Set the main switch to "ON".
d. Turn the lean angle sensor 45°.
e. Measure the lean angle sensor output volt-
age.
L
LLL
L LLL
L
L LLL
L
L LLL
L
EAS28940
CHECKING THE STARTER MOTOR
OPERATION
1. Check:
• Starter motor operation
Does not operate → Perform the electric
starting system troubleshooting, starting with
step 4.
Refer to "TROUBLESHOOTING" on page
8-9.
M
MMM
M MMM
M
M MMM
M
M MMM
M
a. Connect the positive battery terminal "1" and
starter motor lead "2" with a jumper lead "3".
EWA13810
WARNING
• A wire that is used as a jumper lead must
have at least the same capacity of the bat-
tery lead, otherwise the jumper lead may
burn.
• This check is likely to produce sparks,
therefore, make sure no flammable gas or
fluid is in the vicinity.
L
/G
B
/L
1 2
L LLL
L
L LLL
L
LLL
M MMM
M
M MMM
M
MMM

Advertisement

Table of Contents
loading

Table of Contents