GE LOGIQ E9 Service Manual page 505

GE
D 5573152-100, R
IRECTION
8-9-4-1 BEP Side I/O Board - BEP6.x removal
Table 8-136 BEP Side I/O Board - BEP6.x removal
1.
Disconnect all I/O cables and all cables at the top of the BEP. See:
connectors - J5 PCIe to GFI2 is present on GFI Configuration" on page
2.
Loosen the thumb screws or screws at the top of the BEP cover, or the three screws that attach
the cover to the BEP.
Tilt the top of the BEP cover away from the BEP.
3.
Disconnect:
• the battery cable from PCN1.
• the CB to PB cable from PCN2.
Place the BEP cover aside.
4.
Remove the Option Dongle, on the I/O
Board, inside the BEP.
. 2
EV
Steps
Chapter 8 Replacement procedures
LOGIQ E9 S
ERVICE
Corresponding Graphic
Figure 8-57 "BEP6 cable
8-208.
BEP6 CB cables
Option Dongle
M
ANUAL
8 - 221